Wiring Connectors Harness Plugs 3SX - 3-pin Triangle

3SX Wiring Harness Connector Plugs
3-Pin Triangle Male & Female

This is a wiring harness connector plug kit that is a used on the 3000GT/Stealth/GTO, as well as many other Mitsubishi vehicles. This particular connector comes in both male and female plugs that mate together. We offer them separately and as a bundled pair.

 

3-Pin Triangle MALE Plug

 

3-Pin Triangle FEMALE Plug

 

NOTE: These plugs are unassembled as pictured at top and wire is not provided.
You will need a wring crimping tool to assemble. Make sure any rubber boot seals are on the wiring BEFORE crimping on the metal terminal. Once the terminal is crimped onto the wire, it is inserted into the plug housing and the boot seal pushed into the back of the plug housing. The plastic guides/inserts for the front of the housing are clipped into place last.

 

Known Applications

Following is a list of known applications for this harness plug connector.
Table Note: H = Harness side of connection | P = Part side of Connection

Application / Location	MALE	FEMALE
Crank Angle Sensor 93-99 Sensor at Crank	P	H
SUB*: Cam Angle Sensor 93-99 Sensor at Crank	P	H
SUB*: Oil Pressure Sender/Switch Harness	P	H

* SUB - This plug can be used in place of the original plug if replacing both the Male and Female halves together.

 

Crank Angle Sensor 93-99 DOHC
SUB: Cam Angle Sensor 93-99 DOHC
NOTE: The Triangle plug set can be used for the Cam Angle Sensor if you replace both the male and female plug ends on both the part and harness sides.

SUB: Oil Pressure Sender/Switch Harness (rear plug on plenum harness set)
Note that using this plug at this junction requires replacing both the male and female plugs on both the part side and the harness side. We recommend placing the new Male plug on the part side as it has the clip to mount to the bracket on the plenum.

 

NOTE: These plugs are unassembled as pictured at top and wire is not provided.
You will need a wiring crimping tool to assemble. Make sure any rubber boot seals are on the wiring BEFORE crimping on the metal terminal. Once the terminal is crimped onto the wire, it is inserted into the plug housing and the boot seal pushed into the back of the plug housing. The plastic guides/inserts for the front of the housing are clipped into place last.

NOTE2: There are NO RETURNS on these plugs once they have been assembled, partially assembled, terminals crimped to wire, or altered in any way from being NEW.

 

 

---

Harness Plug Crimping Tool

We also offer a Molex style wire crimping tool that works well with these harness plugs. Order this in addition to your harness plugs for your complete wiring solution.