3SX Stinger Fiberglass Hood

3SX "Stinger" Hood

1st Gen + 2nd Gen Hoods are special order - ETA 1-3 Months

NOTE: All Hoods are exempt from any Free Shipping offers. Since our shopping cart system can not calculate shipping for a hood going freight, shipping will be calculated and charged separately to the same card used to place the order. USA Freight is $650. Canada is $750. Other destinations will be calculated.

After a year and a half of design, development, and production, we finally have our custom fiberglass vented hoods! Not only does this hood shave precious weight - it's only 27 pounds, over 35 pounds lighter than stock! - but it has fully functional inlet and exhaust vents. The front-n-center vent directs fresh air over to the passenger side onto the air box/filter. And the pair of vents in the rear allow heated underhood air to escape, yielding much better air flow through the engine compartment and more cooler air around the engine - with the added bonus of not allowing water to flow into your engine compartment.

Owner: Chris McAndrews

NOTE: This hood is a light-weight hood and will NOT work with your stock hood shocks/struts. You will need to run without hood struts. Also, as with any lightweight hood, hood pins are necessary.

Note:  These are special order eta 1-3 months wait time prior to shipment.

Note:  These are non refundable.

Note:  Flat Shipping Fee will be applied when ordering this item of $500.00 to the lower 48 states.  Anywhere else shipping will be recalculated.

Note:  Doesn't come with a hood Latch.  Recommend Hoods pins and low tension hood struts with item.