CXRacing Aluminum Pre-Turbo Intake Pipes
for TD-04 Draw-Thru Setup
This is an intake pipe upgrade for the 3000GT/Stealth/GTO that replaces the "preturbo" intake pipes - the rubber pipes between the intake splitter bubble and the inlets of the turbos.
When installing these pre-turbo pipes, you DO have to use the rubber "spacers" that are in the stock pipes that adapt the pipe/coupler down to the smaller inlet size of the turbo, or you can use the new 3SX Pre-Turbo Intake Pipe Seals. Simply pull the rubber ring out of the stock pre-turbo pipe and slide it into the silicone coupler or install the 3SX PTIPS. Then the coupler slides onto the turbo inlet. Clamp into place.
The spacers are required for stock turbos, 3SX Eliminators and Executioners, 13g/13t, 15g, 16t, DR550, DR650, and other "stock housing" TD04 turbos. The 19T and DR750 turbos have a modified compressor housing inlet with a 2-inch outer diameter, so the straight coupler will fit right on the turbo without the use of the spacers.
The kit includes the 2 pipes, 2 blue couple, and 4 hose clamps.
NOTE: If you have eliminated the need for the vacuum nipples, we offer vacuum caps separately. You will need one of each 1/4-inch and 1/2-inch for these pipes.