AWD Getrag Transmission Internals 3000GT / Stealth
Transfer Case Bearings
We have a selection of the bearings for the transfer case from both the 5-speed and 6-speed all-wheel-drive Getrag used in the 3000GT VR4 and Stealth Twin Turbo models. Pictures are provided for you to match your parts if you have it in your hand and are not sure which one it is. :-)
<< Cover Side -- Input Spool -- Tranny Side >>
The 5-speed transfer case is typically distinguished as either 18-spline or 25-spline. Unfortunately, this fact is not *always* true for the internal bearings. The internals are typically referred to in "big bearing" and "small bearing" terms. The 5-speed input spool uses different bearings that are not necessarily directly correlated to the 18/25 spline distinction. You can determine if you have the BIG or SMALL bearings in yours by measuring the outside diameter of the bearing races that carry the input spool (the race is the part the bearing actually rides in that is pressed into the casing of the transfer case - it's smooth on the outside and angled in the inside where the bearings roll). As you will notice form the table, it's not a big difference between the SMALL and BIG bearings.
Please confirm which bearings you need prior to ordering.
In the picture the RACE is angled up on the tapered roller bearing.
NOTE: All parts are sold individually and quantities are limited. Parts not listed in the selection menu below are not in stock or are no longer available for ordering.