Wiring Connectors Harness Plugs 3SX - 2-pin Female - Injector Quick-Release

3SX Wiring Harness Connector Plugs
2-Pin Rectangle Female Quick-Release
Perfect for Fuel Injectors!

This is a wiring harness connector plug kit that is a used on the 3000GT/Stealth/GTO, as well as many other Mitsubishi vehicles. This particular connector is used a MANY vehicles as it is a plug for the fuel injectors. But unlike the interchangeable standard 2-pin Rectangle Female Plug which can be a chore to disconnect from the part, this quick-release connector is set up to be VERY easy to clip onto and securely hold the part, and then an easy press of the wire clip easily slides it off the part.

NOTE: This harness connector plug is typically directly interchangeable with the standard 2-pin Rectangle Female Plug. The only consideration is the Quick-Release plug is taller so may have space limitations on certain installation application locations. Verify you will have the extra 10mm or so clearance for the taller plug.

NOTE: These plugs are unassembled as pictured at top and wire is not provided.
You will need a wring crimping tool to assemble. Make sure any rubber boot seals are on the wiring BEFORE crimping on the metal terminal. Once the terminal is crimped onto the wire, it is inserted into the plug housing and the boot seal pushed into the back of the plug housing. The plastic guides/inserts for the front of the housing are clipped into place last.

Known Applications

Following is a list of known applications for this harness plug connector.

Fuel Injectors for MANY makes/models

We have a couple SETS available that allow you to completely re-wire your injectors on a 3000GT/Stealth. We have a set for the FWD DOHC Non-Turbo that includes 6 QR injector plugs and the 4-pin plug for the rear bank injector harness. We also offer one for the AWD Twin Turbo with the 6 QR injector plugs and the 6-pin plug for the rear bank connector (pictured here).

Water Temperature Sensor in Thermostat Housing

VICS Motor - Upper Plug - on DOHC NA 3000GT/Stealth

G-Sensor on AWD 3000GT/Stealth - Located under Ashtray

NOTE: These plugs are unassembled as pictured at top and wire is not provided.
You will need a wiring crimping tool to assemble. Make sure any rubber boot seals are on the wiring BEFORE crimping on the metal terminal. Once the terminal is crimped onto the wire, it is inserted into the plug housing and the boot seal pushed into the back of the plug housing. The plastic guides/inserts for the front of the housing are clipped into place last.

NOTE2: There are NO RETURNS on these plugs once they have been assembled, partially assembled, terminals crimped to wire, or altered in any way from being NEW.

Harness Plug Crimping Tool

We also offer a Molex style wire crimping tool that works well with these harness plugs. Order this in addition to your harness plugs for your complete wiring solution.